inner_banner

Product classification

Contact us

Shanghai Sales Centre:

Address: room 2406, greenbelt and Chuang building, 450 Cao Yang Road, Putuo District, Shanghai.

Mailbox: sales@jeffelcn.com

Tel: 021-62586212 0573-88222777

Fax: 021-62586271 0573-88222622

Website:   manlianpte.com/en

武漢MBR-mw-18d

Your current position: Home >> Products >> 武漢Industrial water filtration

武漢MBR-mw-18d

  • Taxonomy:武漢Industrial water filtration

  • Click times:
  • Date of release:2018/10/15
  • Online inquiry
Detailed introduction

Process characteristics:

1.WASTE WATER OPTIMIZATION

Stable Effluent Quality; High Resistance to Water Quality Impact load test; Effluent Suspended Matter and Turbidity are close to zero; Direct Reuse; Realization of Waste Water Optimization  

2.FLEXIBLE OPERATIONAL CONTROL 

The efficient interception of membrane intercepts microorganisms completely in the bioreactor; complete separation of Hydraulic Retention Time (HRT) and Sludge Retention Time (SRT); Flexible operational control.

3.REDUCE LAND AND CIVIL CONSTRUCTION INVESTMENT

The Concentration of Membrane Pool’s Activated Sludge is 8000 ~ 12000 mg/L, which both spares the room for sedimentation basin and minimizes land occupation and construction investment. The occupied area is about 1/3 of the traditional process.

4.REPRODUCTION OF NITROBACTERIA

High systematic nitrification efficiency is beneficial to the retention and reproduction of nitrobacteria. Deamination and dephosphorization may also be realized if the mode of operation is changed.

5.IMPROVE THE DEGRADATION EFFICIENCY

The degradation efficiency of refractory organics can be enhanced greatly since the sludge age can be very long. 

6.CAN ACHIEVE ZERO SLUDGE EMISSIONS

Operated under high volumetric loading, low sludge loading, long sludge age, the reactor yields extremely low residual sludge. Due to the infinite sludge age, theoretically zero-release of sludge can be achieved.

7.EASY OPERATION AND MANAGEMENT

PLC control of system brings a convenient operation and management process.

Zhejiang jeffel Environmental Science and Technology Co., Ltd.was specializes in the R&D, industry manufacture, engineering application and market promotion of the materials and products used for filtration, separation and purification. Since its inception, which has always focused on research and development to promote a variety of new materials and products were separated by filtration, the polymer separation membrane materials and equipment.

                                                                MBR膜組件參數 | MBR Membrane Components Specifications





                           性能

                        Performance


設計通量

Design Flux

10-25L/(m2·h)根據水質不同適當選取

Select According to Different Water Quality

產水濁度

Produced Water Turbidity

≤1NTU
TSS測不出

產水大腸桿菌

Escherichia Coli In Producing Water

10FCU/100ml

污泥濃度

Mixed Liquid Suspended Solids(MLSS)

4000—12000mg/L

 




                           規格

                      Specifications


膜絲材質

Membrane Filament Material

PVDF材質(帶襯工藝)

PVDF (with liner)

內徑/外徑

Inside Diameter/outer Diameter

1.0/2.2mm

粘結材料

Bonding Material

聚氨酯/環氧樹脂

PU/Epoxy Resin

連接管材質

Connecting Pipe Material

ABS




平均孔徑

Mean Pore Size

0.03um

接口尺寸

Size Of Interface

DN32/G1/2快插






                          使用條件

                    Operating Condition

工作溫度

Operating Temperature

15—35℃

設計工作壓力

Design Operation Pressure

-80Kpa—0

PH耐受范圍

Ph Tolerance Scope

2-12

曝氣量

Aeration Rate

膜面積:2.5L/(m2·min)

設計反洗壓力

Design Backflush Pressure

0.05-0.2Mpa




                          維護性清洗

                     Maintenance Cleaning

清洗頻率

Cleaning Frequency

1次/周

Once a week

清洗時間

Cleaning Time

30-60min/ time

清洗藥劑

Cleaning Agent

次氯酸鈉 Sodium Hypochlorite: 200-500mg/L; 

檸檬酸/草酸 Citric Acid:1000-2000mg/L





                          恢復性清洗

                     Restorative Cleaning

藥物清洗頻率

Cleaning Frequency by Pharmaceutical

1次/3個月或跨膜壓差達到50Kpa時

Once three months or Trans-membrane Pressure reaches 50Kpa

清洗時間

Cleaning Time

1 次/6小時 

Once 6 hours

清洗藥劑濃度

Cleaning Agent Concentration

次氯酸鈉 Sodium Hypochlorite: 2000mg/L;

檸檬酸/草酸 Citric Acid: 2000-4000mg/L



                                                                   MW系列膜片信息 | Information of MW series Membrane

規格

Specifications

膜面積

Membrane Area

膜片有效長度

Membrane Effective Length /mm

膜絲數量

Membrane Filament Quantity

MW12b12m210701560
MW16b16m214801560
MW20b20m218001560
MW25b25m222901560
MW36c36m218402880
MW15d15m215001440
MW18d18m218001440
MW23d23m223001440
MW33e33m218302660

 


Technological characteristics of MBR diaphragm

The address of this article:http://manlianpte.com/en/product/560.html

Key word:MBRdiaphragm,MBRmembraneforsewagetreatment,MBRdiaphragmproductionplant

Recently Viewed:

relevant news:

relevant news::

.png

WeChat 2D code

Shanghai Sales Center:
icon1.png

Address:Room 2111, Greenland and Chuang Building,

No. 450 Caoyang Road, Putuo District, Shanghai

icon2.pngEmail: sales@jeffelcn.com
icon4.pngTel: 021-62586212
icon3.pngFax: 021-62586271
Zhejiang production base:
icon1.png

Add: No. 370, Century Avenue, Development

Zone, Chongfu Town, Tongxiang, Zhejiang, China

icon2.pngEmail: sales@jeffelcn.com
icon4.pngTel: 0573-88222777
icon3.pngFax: 0573-88222622


分享 一鍵分享
Please leave a message for us
Please input the message here, and we will contact you as soon as possible.
Full name
Contacts
Telephone
Seat / mobile phone number
mailbox
mailbox
address
address